SD Screw Down VentSaver Mounting Plate (Without VentSaver)


(No reviews yet) Write a Review
In Stock
Adding to cart… The item has been added

The SD (Screw Down) VentSaver mounting plate is for applications where the wood decking is less than one inch or situations where the pipe is off center to the panel flat. This plate works with any VentSaver model and comes with 12 three-inch fasteners that can be screwed into as little as 1/2” of decking below. The plate is 27 inches wide and spans over the high ribs to provide adequate surface area for the VentSaver to be adjusted to compensate for off center pipe placements.

SD Mounting Plate Instructions             SD Mounting Plate Cut Sheet            SD Mounting Plate Specification

VentSaver EZ, HD, & Extreme! A Lineup of Vent Pipe and Chimney Protection From Sliding Snow & Ice!

Warranty Information

The following warranty supersedes all other expressed or implied warranties. Reliable tests are used as the foundation for recommendations for how to utilize the product properly. In no event shall the manufacturer be liable for damages in excess of the purchase price for any products that are found to be defective because of materials other than replacement or refund of the purchase price. The user is responsible for determining whether the product is suitable for the application for which it is designed and for assuming all associated risks.


(No reviews yet) Write a Review




671 Willow Street

Lemoyne, PA 17043