- Extra-Wide 4-Inch Face Accepts Color Strip for Color Matching
- Aircraft Grade 6063-T5 Aluminum with galvanized fasteners
- No need for messy sealants with the included foam base gasket.
The SnoCleat PBR is a mechanically fastened PBR or R panel-specific snow guard made entirely of aluminum. The 6 pre-drilled holes were carefully placed to allow for simple attachment of the snow stops to a purlin through the panel. A minimum of three #14 roofing screws with neoprene washers are used to mount this device. In the remaining holes, additional fasteners may be inserted if more holding power is required. In place of glue or liquid sealant, a foam gasket is provided for placement between the guard and the panel. The SnoCleat PBR has a substantial 4-inch-wide face that is secured by two tek-screws.
A color strip that matches your roof and is optional, measuring 4 inches wide by 2 inches tall, can be attached to the guard's face.
Only screw down installations are permitted for the SnoCleat PBR, and adhesive mounting of this guard is not advised. It is not advised to utilize snow guards in isolated roof areas including chimneys, doors, vents, and partial roof sections. Screws for mounting are supplied separately. Always read the spacing recommendations before making a purchase.
Optional Color Matching: A color strip that matches your roof and is optional, measuring 4 inches wide by 2 inches tall, can be attached to the guard's face.
SnoCleat PBR Spec Sheet SnoCleat PBR Cut Sheet SnoCleat PBR Installation Instructions
