RC RoofClamp


(No reviews yet) Write a Review
In Stock
Panel Compatibility:
Various metal roof panels with standing seams as wide as one inch.
Adding to cart… The item has been added
  • Produced in the USA
  • Simple and quick installation.
  • Secure satellite dishes, HVAC lines, conduit, and roof pathways.
  • Prevents piercing or penetration of the panel. won't invalidate the manufacturer's warranties.
  • It only requires 90-inch pounds of torque, which is far less than some other clamps' requirements.
  • Preinstalled screws help you save time and money.

With SnoBlox RoofClamps, virtually any accessory or product can be attached to your roof without damaging your standing seam roof. For a quick, hassle-free installation, our unique design slips over practically any roof seam. Use SnoBlox RoofClamps to make sure you won't invalidate manufacturer warranties by puncturing or penetrating roof panels.


SnoBlox RoofClamps utilize set screws with coarse threads, in contrast to rival clamps. Roofclamp RC can be reused since this style of threading eliminates set screw lockup. Our clamp allows you to unscrew and reuse the clamp, unlike the majority of other products on the market that require cutting off with a grinder.


Three cupped-tipped screws made of stainless steel are used with the aluminum RoofClamp. The clamp's attachment is made of a single piece rather than two, and it contains three set screws as opposed to one or two for added sturdiness. It will endure the entire life of the roof and is quick and simple to install. These two reasonably priced versions function on the majority of the same panels as the nine other clamps already available. Three cupped-tipped set screws measuring 1-1/4" X 3/8". On top, there is a single 3/8" mounting hole. A well-known, nationally known, and trusted facility has shear and tensile tested the RoofClamp RC and RCT mounting clamps.

Safe for Roofs

This patented clamp attached to the seam from the top. Since the clamp is made of one piece, it does not need to be fed up along seams. Most seams up to 1" wide can be accommodated by the RC model. The inside is 1" wide by 1" high. The manufacturer guarantee will not be voided because the stainless steel cupped tip screws used by the aluminum RoofClamp do not pierce or penetrate the panel.

Panel Compatibility      Instructions      RoofClamp Spec Sheet    RoofClamp Cut Sheet


Roof Clamp Standing Seam Metal Roof Mounting Clamps

Warranty Information

The following warranty supersedes all other expressed or implied warranties. Reliable tests are used as the foundation for recommendations for how to utilize the product properly. In no event shall the manufacturer be liable for damages in excess of the purchase price for any products that are found to be defective because of materials other than replacement or refund of the purchase price. The user is responsible for determining whether the product is suitable for the application for which it is designed and for assuming all associated risks.


(No reviews yet) Write a Review




671 Willow Street

Lemoyne, PA 17043